Joey Joebags Gen 3 Full Size replacement shell

I have uploaded two different versions. V1 should fit but it's larger, has looser tolerances, and is completely untested. I don't actually recall making it. I went to print it but decided I could do better so I made V2. V2 is what is pictured and tested.

I redesigned the case for the full size joey joebags gen 3 from BennVenn (the one with Mini USB). Joeys all already come with 3D printed cases but I wanted to make a matching one for the gen 3 mini that I had to replace the case on. Rather than contact BennVenn for a new one, I decided to create one that is lower profile. Compare this case (cyan) to the original (yellow) in the images.

You may need to trim the header pins on your joey to install this. I can't remember how they come and I have taken mine apart and reassembled several times (to correct an issue with the USB port) so I've already modified the header pins.

The bottom casing snapped on just fine and is holding there and the top casing is held down with a few globs of hot glue on the periphery.

This case will ONLY fit the original gen 3, not the gen 4 (jr) or any of the "mini" gen 3 units. This does not fit any other aftermarket units either.

I have also made a case for the gen 3 mini here: https://www.thingiverse.com/thing:4051396

Category: Electronics