February 28, 2022
Description
We had a Curt 2 inch trailer hitch installed on my wife's van. We also got the wiring installed so we could tow a small trailer we have for camping. With the basic installation we had done the wiring was always falling out of its various hiding places or places we tuck it.
This Trailer Hitch Receiver Cover has a slit in the cap to allow the plug and some additional wiring to be pushed into the receiver so it doesn't hang down and get destroyed.
The cover should be snug but easy to put in and take out. Also has two button ears that should match with the hole for a pin and hold the cover in place.
Our driveway angle is always causing the receiver to drag on the driveway as we drive in or drive out. So I have also made the cover slightly smaller than the exterior perimeter of the receiver.
Printer:
Anet A8
Rafts:
Doesn't Matter
Supports:
Yes
Resolution:
0.2
Infill:
15
Notes:
I printed this with PETG from Zyltech. I print with a small brim to make sure it doesn't warp
License:
Creative Commons — Attribution — Noncommercial
9
arnmac
