Budgie Ladder

Our budgies chew through wooden ladders, I printed a replacement.

The ladder is too large for my Prusa Mini+ so I cut it in half (170mm) in the slicer and placed the two parts on their side. I reused the screw-hooks from the original wooden ladder, made a small hole in the top of the printed ladder to screw them into.

Print Settings - Ladder

1. 0.2mm
2. Support on build plate only - Snug Supports

Print Settings - Connector Sleeve

1. 0.2mm
2. Brim

After printing I cleaned up the supports/brim then glued the two pieces together.