Flagpole Rings

Telescoping flagpoles require an additional Ring, to set the flag at half mast.

Half mast is in honor of those that are well deserving of the tribute.

This set includes 4 rings. 

• S-39mm
• M-49mm
• L-57mm
• XL-65mm

A retainment pin with cap is included. The cap strengthens the pin.

I also created flag clasps, in another model upload. Check them out. https://www.printables.com/model/1425331-flag-clasps

This model is a hinged design. Print in place. Print all as one assembly. Ignore cantilever warning. Either use build plate only support or no support, otherwise the hinge may not work.

After printing, use a small screwdriver, to carefully nudge it open, in the area where the retainer pin will go.

UPDATE: 19 Oct 2025 included pins with smaller retention to make them easier to remove.