@Lukes3D telescopic mini tripod is great, but I found out that it's not possible to rotate or tilt my camera with it. So that's why I designed this model - special extension which gives you more flexibility while using the tripod.
Features:
Rotate and tilt camera
Special bolt for adjusting strength
Portrait mode support (depending on your camera you may need to shorten one leg in order to keep it stable)
Parts:
Bottom screw support - attaches extension to the tripod
Main knob - base
Tilt lever - holds the camera
Bolt - adjusts strength of tilting
Rubber pad bottom, Rubber pad side - keeps rotation and tilt stable, print with TPU
And screws:
1x M3x20
1x M3x10
1x M3x14
4x M3 nut
Assembly:
Read the step-by-step instruction or just look at the animation below:
Place a nut in the Bottom screw support
Insert the Bottom screw support from the bottom of Top plate (top part of @Lukes3D tripod)
Place Main knob on the top of Top plate, with Rubber pad bottom between
Insert M3x20 screw into the middle hole in Main knob and tighten it
Then, place Rubber pad side, one of each side of Main knob (look at the rows)
Put on Tilt lever carefully, paying attention that the Rubber pads do not fall out
Insert next two hex nuts into remaining holes at the top of Main knob
Insert the M3x10 screw into the bigger hole in Tilt lever and tighten it
Take a next nut, and screw it into the M3x14 screw (to the end)
Take this screw and insert it into the Bolt (the side with hexagonal hole)
Insert this piece into the second hole in the Tilt lever and tighten it
W&H
