Lenovo Mini PC 10" 1U Mount. (M710q, M720q, M920q, M93p)

Description

This is a 1U mount for 10" mini racks. I made it so the mini PC slides in from the front as I preferred to install the mount and then add the PC. I found this also was easier for maintenance, all I have to do is push the back of the mini PC and then grab the front.

Printing took me about 8 hours on my MK2.5s with 15% infill. The print used about 110g of filament. 

While there is no rear support, the sagging was minimal. Defiantly a slight sag at the very back but nothing that's out of the usual. If any problems arise I will post an update. 

Supported Lenovo Models

I have designed the mount to fit a couple different mini PCs as I have a couple. The mini PCs are very similar except the bottom feet.  

Tested and Confirmed:  

• M720q
• M93p

Suspected to work based on physical dimensions: 

• M710q
• M910q
• M920q

If you have any models not listed here and you print this design please post a make or leave a comment and I will update the list.