Diamond Tool Holder height gauge

for the Eccentric Engineering Diamond Tool Holder 8mm (5/16") Tool Height (11mm Shank) Needs to be set at 8mm from the bottom of the 11mm thick shank, aka 3mm down from the top

- one side drapes over the diamond tool holder on the far side for positioning/locking.
- and then also leans into the qctp holder for positioning stability.
- then drops 3mm down so that any toolbit (sharp, flattened for brass, round) is always at the same height (8mm).
- and thus if I do need to change bits, I do not have to align it to the lathe center each time, was the idea at least.
.