Drill Bit Storage ( 1/4 Inch Hex Shank )

The Model was made for a Tapered Countersink Drill Bit Set with 1/4 Inch Hex Shank but may work for anything similar.

Print with whatever settings float your Boat - Personally I'd recommend at least 2 Perimeters and like 20% Infill.

The Model has provisions for inserting 6x 8x3mm Round Magnets into the Bottom which should keep things held in place if the Cup gets knocked over. If you want to use that feature you'll have to set a Pause at the appropriate height:

In the above example you'll notice I've turned the Model Upside Down which gives me a nicer Top Finish ( because of the Textured Bed ) at the cost of requiring Supports - If you don't care for either just print it Right Side Up.

You may notice I've also added a bunch of Height Range Modifiers like one for Scarf Joints for the red & white Parts and Fuzzy Skin for the black Areas. Seam was set to Nearest to get it to randomize across the Fuzzy Area and then Hand Painted for everywhere else ( kinda wish there was an option to have Fuzzy Skinned Areas automatically have randomized Seam Placement in them ).