[ACOS] Ikoka Stick Beam Case

Commercial Use and Attribution Notice

©2025 by Majestic AV, LLC. is licensed under CC BY-SA 4.0.

Commercial use of this design, including promotional use, selling, and reselling to other businesses for sale, is permitted under the following conditions: Prior to any commercial exploitation, you must contact Alley Cat or MajesticAV, LLC to ensure proper attribution and licensing terms. By law, this requirement extends to any sharing, distribution, or creation of derivative works, including manually crafted designs that emulate this design. Proper attribution must be clearly stated in all instances of use. For official contact methods and further information, visit Majestic AV, LLC - Alley Cat. Any other sources are unauthorized and should not be used for commercial or licensing inquiries.

Disclosure: Some links on this page may be affiliate links. If you make a purchase through them, I may earn a small commission — at no extra cost to you. I only recommend gear I trust and use myself. Thanks for your support!

Suggested Print Settings

Material: PLA+ or PETG
Nozzle: 0.4mm
Extrusion Width 0.4mm
Layer Height: 0.2mm
Perimeters: 3
Infill: 10%
Top/Bottom Layers: 5
Support Material: None

3D Printing Disclaimer

Thank you for downloading my CAD design! I want to assure you that extensive testing and iteration went into creating this design. However, please keep in mind that 3D printing involves a wide range of variables, including different types of filament, printer settings, and calibration levels. These factors can significantly impact the final print.

Before concluding that the design is flawed, I encourage you to:

• Check your printer calibration: Ensure your printer is properly calibrated. Especially filament shrinkage.

• Adjust print settings: Try changing the print settings to achieve better results.

• Resize the model: Scaling the model up or down slightly may resolve fit issues.

Remember, these are development boards and sometimes have very fragile parts. If you encounter any issues or need assistance, please feel free to reach out to me. I am here to help and can provide guidance to achieve the best results. Claiming a design is bad without considering these variables does a disservice to the community and may discourage others from trying a design that could work perfectly with minor adjustments.

Thank you for your understanding and cooperation. Happy printing!

Description

Custom case for the standard Ikoka Stick based on my T-Beam cases. Also uses the same mount system. If you have any variation from the standard BOM for this device, please join my Discord and let me know, and I will modify it to fit if reasonable.

FRONT

Screw Front: Has holes for standard M3 socket head screws to hold the back cover on. 

No Screw Front : Uses friction to hold the back cover on.

MeshCore Front : Has the MeshCore logo on the front.

BACK

 Back Inserts: This one has holes M3 heat set inserts.

Back Nuts: The one has holes for M3 nuts.

PARTS

OLED spacer: Put this on behind the OLED to hold it in the right place.

Grommets: Gizont for the popular Gizont 17cm antenna, 13mm works with most basic bendable antennas. Use no grommet for the big tacticool gooseneck.

Button: Put it in the button hole before you install the board.

Video

Coming soon!