Philips Hue Bridge Bracket v2

This is a smaller version of the original design that uses less plastic. It features:

• tight friction fit for the bridge

• ability to mount the bridge without disconnecting wires

• does not block access to the button and LEDs

• screw holes for horizontal mounting patterns

• design optimized for 3D printing thus 45-degree angles

• wall thickness optimized for 0.4mm nozzle

Print instructions

• Place it vertically parallel to Y-axis for best stability

• Optimized for 0.4mm nozzle

• Originally printed with PLA

Disclaimer

This design relies on friction fit and several people reported that it fits to tight. It is known issue as friction fit on shrinkage rate of the filament. If it helps, the filament I used was (likely) Prusa PLA, so you mileage may vary with other filament types.