Centauri Carbon panel riser (10mm)

Elegoo Centauri Carbon compatible panel riser for internal spool mod. 

Panel is raised by 10mm to allow for internal spool mounting and prevent bed from crashing into the spool holder.

Hardware needed:

• 12mm M3 Screws (8 pcs) (can be slightly longer I believe)

I wanted to make a simple, panel riser that does not require any special tools, like heat inserts. Some very small gaps are presents between joints. First print seen in the picture had too large roundings in the panel edge inlay, I have fixed that now. I did not use any glue as I found that the panel held together just fine when installing it (this depends on how tight the pins print out).

Printing: Separate models in slicer by right clicking the riser and selecting “Split” → “To objects”.

Recommended to print in PETG or more heat resistant and tough materials.