This is the simplest and quickest to print dry box I can imagine. It holds 3 spools. You need only the following:
- Superglue
- Two prints of (SteriliteHolder.stl)
- One Sterilite 20Qt (19L) gasket box available everywhere! target, amazon, walmart, etc
- 1/4 inch or 6mm rod. 14 inches or 35 cm length homedepot, amazon
optional:
- Some kind of push fit connector and tube amazon
- Desiccant
Assembly instructions.
- Apply glue to your printed parts and stick them to either end of the box. Keep them in place with a piece of tape while the glue dries. It's important they are roughly level and upright
- Measure your rod and cut it to length with a hacksaw or whatever means you need.
- Done
- Optionally drill a hole through the box and screw in your push fit connector. (PushFitNut.stl)
Category: 3D Printer Accessories
bostwickenator
