SN-1 Rudder Pedals Comfort Pads

Recommended tape, the 3D printed knurling is hard to clean: https://aliexpress.com/item/1005009201004263.html

Hardware required:

  Clamp Version:

• 4pcs. M3x20

• 4pcs. M3 nut
   

  Standalone Version:

• 2pcs M8x150

• 2pcs M8 Nut

You'll lose the ability to use the lowest angle positon with the Clamp Version.

Print settings:

• No supports (model has built in supports)

• 6 Walls

• 30% infill

Has space for these microswitches:
https://aliexpress.com/item/1005009404714469.html

You can either solder them to a different board or directly to the STM32 bluepill board that's inside these pedals, it's running freejoy firmware so you can configure it with freejoy Configurator.