DJI Controller iPad Pro 11 Inch Holder With Wider Edges

This is remix of Jacques Creton's iPad Pro 11 inch holder from Thingiverse website. In this model, i increased edges of holder significantly to hold the iPad better. Also, i increased top side aperture of holder from 7 mm to 9 mm for adding extra soft materials to not stratch the iPad. In my case, i used glued soft tape (You can also use foam or something like this) to prevent my iPad get stratched by holder. Again thank you Jacques Creton as providing step model of file. I also added here my step file for further improvements.

Print Settings

• Printer brand: Creality
• Printer: CR-6 SE
• Rafts: Doesn't Matter
• Supports: Yes
• Infill: %20 would be enough
• Filament brand: Mikrozey
• Filament material: PLA
• Notes: Please print the model as vertical (Widest surface of holder shouldn't touch any support to get better surface. Because widest surface directly touch to iPad) (I added print preview picture)