October 21, 2025
Description
I created this model using Onshape to have the possibility to print with other materials and colors. I made the holes in the bottom but didn't test yet with the rubber ring, maybe that will need some adjustments.
I enabled support for the “carved” part in the bottom, didn't try to print without it. Maybe it would be fine too.
The model in the photo I printed with a 6mm nozzle (0.24mm layer height), PLA, but I uploaded the profile for a 4mm nozzle (that is more common). It will be OK with any nozzle.
Obs.: If you normally use a dishwasher, don't print in PLA…
Hope you like it!
License:
Creative Commons — Attribution — Noncommercial — Share Alike
Edmundo Barbosa da Silva
