Low hang Belt loop For Radios

I needed a general purpose loop for my radios that would allow it to sit lower than if on my belt. This then allowed it to be easily accessible  when wearing a jacket or outdoor top as it sat below its bottom. It would also make it easier to use as it would not get hung up when removing etc as it does on a normal belt.

So here is my universal Belt Loop for radios..

Designed to fit belt upto 4cm deep and pretty much allow any radio to use it, whilst having enough room between the radio and loop to easily remove and reattach it. And easily accommodates a flashlight on it too!!

Added a V2  versions which has been strengthened so works  well for PLA filaments..

V1    Print with 4 walls and a minimum of 10% infill.. seems too wok well..

V2    Print with 4 walls and a minimum of 25% infill (Recommended for PLA)