Headphone Holder for Ikea Skadis Pegboard

Built this headphone holder as others I could find didn't really seem to suit larger headphones, and would hold them with cups against the board leaving them to sit at an angle.

This holds the headphone band 48mm off the pegboard (to center point of headphone holder). The band holder is about 40mm wide.

It uses 3 built-in pegs and are a version of skadis pegs I've iterated on to hopefully be quite strong.

TBH, this is a bit of a pain to print as it requires supports. I've tried to reduce them in this version of the design, but they're still needed for the headphone curve and pegs. I had success with tree supports.
I would typically add a modifier for the pegs to make them 100% infill.