November 4, 2025
Description
Just another basic holder to fit this 4 piece nut driver bit set. They could have gone into a single square vertically, but that would have been too tall to fit in the low drawer I need to put them in. So I laid them flat in 1x2 squares. Usually, I print Gridfinity with a 0.6mm nozzle, but due to the limited space between recesses, I recommend printing this one with a 0.4mm nozzle for best results.
Like my other Gridfinity models, the base is altered to accept 6x3 magnets as a press fit, with the upper surface of the magnet holes modified to make the slicer bridge across correctly for a clean result.
The unit pictured was printed out of Overture PLA on my bear upgraded Mk3S+, using a 0.4mm nozzle, at 0.2mm layer height.
License:
Creative Commons — Attribution — Noncommercial — Share Alike
8
Netpackrat
