Vacuum Tool for TightSpace

This part was tested extensively. At first, I printed it in a vertical orientation, but that resulted in low strength due to the layer direction. Next, I tried printing it lying flat on the print bed, which caused a lot of stringing since I didn’t want to use internal supports.

To solve this, I made the following adjustments in the slicer:

• Set the print orientation to 45°.
• Increased the support threshold angle to 45°.
• Disabled supports on the inner surfaces of the attachment to keep the inside clean.

After these changes, the print quality and strength improved significantly.

I hope you enjoy the design and find it useful!