Filament Rack fittings for 1/2" PVC

I made a filament rack out of PVC and printed the fittings.  These are a fairly tight fit for ½"PVC.  I didn't need glue but I'm sure it wouldn't hurt.  I tested out if I could glue PVC to PLA with PVC glue and primer, PVC glue no primer, and super glue.  All those methods of gluing worked great.

There are 2 main fittings.  The base tee90 and the regular tee90.  I designed them to be optimized for printing.  The other parts are optional.  I made plugs for the open ends of the unused tee90's and a plug foot for the front.  It adds a bit of stability and a lot of pleasing aesthetics.  I made some 90's for the top rack.  Those are not at all necessary but I think they look good.

Printed on Prusa Core One

Layer height: 0.16mm, 0.2 would probably be fine too.  I just like smaller layer height.

PLA Jayo marble ash concrete 

Supports: NO

PVC lengths:

Long side: 400mm about 15 ¾ "

Short side: 75mm about 3"

Vertical sides: 205mm about 8"

Make up whatever works for you.

Feel free to make up anything else with these pieces.  Please post interesting makes.  Enjoy.