RJ45 Desk Clamp

I like to play around with electronics and mini pcs etc and I often find myself in need of a hard wired network connection. This remix allows to add a network port onto my desk in a convenient spot.

This remix adds a patch panel port suitable for a standard keystone connector - this is the exact type I used - I bought a set for my 10" rack and had some left over:

https://www.amazon.co.uk/dp/B01GFWSSYQ

The cable on the back will be difficult to remove due to the orientation of the port - if you feel this will be a problem, there is also an inverted port version that will allow you to insert the keystone upside down for easier cable removal.

There is also a lid for this remix, but be warned it's not very good, but good enough for my use case.

The screw and screw end are direct from the original clamp model, where there is an alternative end if you find the need for it.

Printing

I printed in PETG to allow some flex when tightening the clamp to avoid it breaking. PLA should be fine but be careful tightening it.

It should be printed on its side and supports will be required for the keystone hole.