Massage Gun 2oz Paint Shaker

This is an attachment for a massage gun to shake 2oz bottles of paint.  It should work with most if not all bottles.  the massage gun used was a Darkiron which is just a generic cheap massager from Amazon, so check the shaft diameter before printing to make sure it fits.   The diameter of the model is 18.6 mm with a length of about 22.34.  There is an impression at the top of the shaft for a rubber ring.  This is used for extra grip so it doesn't shake loose.  My massage gun came with extras for attachments, but a rubber band would also probably do the job.  Additional rubber bands should be used to hold the paint bottle in place as shown.

• Material: PLA+/PTEG.  I used PLA+ regular PLA might work, but it might be too brittle to withstand the impact of the massage gun over time.
• Nozzle: 0.4
• Layer height: 0.2
• Orientation: Flat on back as show in pictures.
• Support: Below the shaft.
• Strength: 3 walls, 15% 3D Honeycomb
  • Optional: The base near the gun is where the strength matters, so you can add a modifier to print the walls around the paint with less infill.  I did 8% Adaptive Cubic.