Holder for TT Motor

this model is designed to be able to screwed into from the bottom with holes for up to 3 m3*3*4.2 heat press inserts. with an addition hole to screw the motor into place but is arguably over kill

if you guys want i can add screw holes on the sides/ more inserts/ different sizes.

INSTRUCTIONS

because of the secure design the motor has to be put in a specific way, first put the side with the little notch towards the main wall then put the shaft in the large hole.

angle the little hole on the end to the sky and press it in (this relies on some elastic bending of the materiel), once the end screw hole is in push the bulge/notch into its hole to ensure proper alignment. 

there is a hole for a heat press insert if you want to screw the motor to the mount but I don't think it is necessary for my application.

printing

i printed in PLA with no supports, 0.2mm layer Hight,  15% gyroid infill, 2 walls.