New Buddy3D camera case for 3D Upfitters and generic enclosures.

This model integrates three slots for 3×10×2 mm neodymium magnets, one in each corner, instead of the four magnets used in the original design.

My goal was to use it in my 3D Upfitters enclosure with my recently upgraded MK3.5S. 

For that purpose, I created a bracket that holds three additional 6×20×2 mm neodymium magnets so the camera can snap securely into place. I also used six M3×5 mm screws to enclose the magnets within the bracket’s thickness.

Ultimately, this gives me a great viewing angle and lets me use the camera easily in my setup.

You could also use the camera without printing the bracket by mounting it in a DIY metal enclosure, as the magnets will hold just as well.

I used ASA @0.2mm for printing.