1U Go-Box Rack Panel

This three piece Rack Panel can be printed on small printers. The models have the cut-outs I used; The component list is below. You can fill-in the holes to make it your own. The panel was designed for Gator Molded G-Pro Rack Cases.

The Center Section screws-on to the Right/Left ends using the screws for the Power Pole Connectors. I used these: https://www.printables.com/model/1110757-anderson-powerpole-small-panel-mount. The support cuts down on the flex. It should be screwed on to the inside of your Rack Case.

Here's a list of the other panel components used:
https://www.amazon.com/dp/B0CQ156G7T?ref=ppx_yo2ov_dt_b_fed_asin_title
https://www.amazon.com/dp/B0CPZX5B3G?ref=ppx_yo2ov_dt_b_fed_asin_title&th=1
https://www.amazon.com/dp/B0DGPXTCRM?ref=ppx_yo2ov_dt_b_fed_asin_title&th=1
https://www.amazon.com/dp/B08L11Q2QT?ref=ppx_yo2ov_dt_b_fed_asin_title&th=1
https://www.amazon.com/dp/B0BHDHRQX7?ref=ppx_yo2ov_dt_b_fed_asin_title&th=1
https://www.amazon.com/dp/B07G25RNZ2?ref=ppx_yo2ov_dt_b_fed_asin_title
https://www.amazon.com/dp/B081C32LWG?ref=ppx_yo2ov_dt_b_fed_asin_title
https://powerwerx.com/panel-mount-usb-65w-qc40-typec-pd