November 20, 2025
Description
This is a 3 piece solution to mount a SG GO shot timer to a Tek Lok mount. The 3 pieces connect via 2 M2 screws and thread into nuts. I made the tolerances very tight so you may need to gently persuade the nuts into the spots for them. You will need the following hardware:
2 x M2x12 screws
2 x M2 nuts
Once attached, put your Tek Lok mounting pieces in the opposite direction and attach to the Tek Lok mount. Your SG GO will firmly lock into place but can be easily removed just by pulling in the opposite direction.
11/20/2025 - I added a cover / mount for a magnet. I haven't tested this.
100% infill / 0.12 layer height / PLA+
License:
Creative Commons — Attribution — Noncommercial
11
Glockenkemper
