November 21, 2025
Description
This is a replacement floppy eject button for the TEAC-FD235F floppy drive that can be found in the Amiga 600.
There are 4 different models. One has a taper on the button which narrows slightly toward the end (like the original), the other has no taper which makes it easier to print as it sits flat on the print bed.
The other two models are the same as above, but the width of the button has been widened slightly to make it better fill the cutout in the Checkmate A1500+ floppy faceplate.
I have also added the step files should you need to modify it. If you do make changes, please share them as a remix as it may benefit other users.
If you are not aware of the Checkmate A1500+ case, then you can check it out here.
https://www.checkmate1500plus.com/
Printer Brand:
Creality
Printer:
Ender 3
Rafts:
No
Supports:
Yes
Resolution:
0.8 - 0.12
Infill:
20%
Notes:
I printed this led flat with supports for the small overhangs on the clip part of the button. it will probably also print well stood upright with supports, so give it a try.
License:
Creative Commons — Attribution — Noncommercial — Share Alike
Lemaru
