Filament guide for Prusa XL

New to Prusa XL, Ive found hard to route soft and brittle filaments through the PTFE tube without breaking them. Sure there are smarter solutions but this one did the job for me.

Feed your filament direct to Nextruder (you have to unplug the PTFE tube). I use this simple filament guide to avoid a complete mesh up while unwinding the filament. 

You can slide the guide through the Y axis of the CoreXY assembly for better accomodate depending on where your prints are located on the print bed. 

There is enough clearance between the guide and Nextruder even at 0 X axis position.