Minecraft Lantern Revamped (STEP-File included)

This Minecraft Lantern inspired model brings cozy pixely warmth to every home.

Caution

Never use real tealights, candles or other burning materials with this model. Best case they're starved of oxygen, worst case your home burns down. Only use electrical tealights/candles!

Needed Materials

• electrical tealight with 37.75mm diameter (can be adjusted via parameter in the STEP file)

• Optional: sandpaper or file (depending on your printer)

Printing

• Material: PLA (I used PETG for the frame and PLA for the panes)

• Layer Height: 0,2mm

• Infill: 10-15%

• Fill Pattern: Gyroid

• Support not needed

Assembly

• Optional: Sand the top holes and pegs if needed to ensure a friction fit without getting stuck

  • tip: drawing with a lead pencil on the pegs leaves a bit of carbon as residue which can act as lube

• Add your electrical tealight or candle 

• Slide in the panes

  • you can decide if you want the layering to face out or in, both works fine

• Put on the top part, making sure not to cant it

  • if the fit is too snug, you can carefully wiggle it free

  • note: if your need to open it, always go slowly, peg by peg and apply counter pressure to the peg you're currently wiggling to avoid it snapping off

  • if a peg snaps off, you can glue it on with superglue

• Enjoy your cozy lantern!

Note

No Blåhaj were harmed in the making of this decor object.