Lakewood Desk Fan Knob

The knob fell off my fan several years ago and I have no recollection of the original knob it had, So i was shooting in the dark.

The original must have been off-center based on the position of the actuator within the body and the part of the motor that juts out the back of the fan. I would have liked to make it bigger, but the knob is about as big as I could make it while keeping the "hole" centered.

This will likely fit several other fans, this specific 3-speed selector switch is fairly common. 

It should just press-fit on.

I printed in PLA with 15% Gyroid infill, 0.1x0.3mm fuzzy skin on the knob body only (not the bore), and with a 5mm brim.