Biker Chick upgrade stronger wheels

upgrade....

reinforced wheels, for when all the spokes fall off with the supports....

much sturdier

This model should come out Awesome.

I had a lot of problems with the supports collapsing. I tried printing on its side and even making some supports... no luck

so it seems you must use some sturdy organic supports but leave enough x/y distance so you can remove them without too much carnage. I printed this one on fast mode and it is very small, only 70mm high. I am now printing one 200mm high...

I shall add a picture if it is not a disaster....!

Oh! yes! Not too shabby .... the 200mm model was really quite a success...

printing upright with organic supports is the way to go!

OK! I lost one leg of the centre stand and I shall need to glue the front mudguard but.... YAY1