Parallel Marking Gauge

This is the “Mark II” version of the Parallel Marking Gauge (or also scriber / ruler / t-square). It does exactly what it says - in increments of 1 mm (or 1/16th inch) - but this version comes with a flattened stop-block and markings on the back. This allows you to turn it around, place it against corners and draw parallel markings using the same holes.

It is a somewhat demanding print and for best results it is highly recommended to use the provided print profiles on a clean build plate. There are 2 colour changes to highlight the markings, either done manually (pauses are set in profiles) or with an AMS.

Print Settings:

0.4 mm Nozzle

0.2 mm Layer Height (also 1st layer)

0.4 mm Line Width

Wall Generator: Classic

Seam Position: Random

Only one Wall on First Layer

No Narrow Infill Detection

for the 25cm and 10 inch Version (diagonal): Infill direction 0°