Dyson V7 V8 V10 V11 V15 Vacuum Accessory Adapter

After learning the basics of 3D design I decided to create this Dyson accessory adapter.

I had previously made one by remixing an existing design, but it was a hash that I bundled together in PrusaSlicer.

This time, I wanted to do it properly, so I created my own model that:

• is sturdy

• fits well

• saves on print material

• can be printed without supports

• can be printed with PLA, PETG, or other filaments.

• requires just 5% infill

• can be printed with large draft layer heights to save time

Tips:

1. Print the model with the narrower opening face down for a cleaner print.

2. Add a brim to ensure good adhesion 

3. Place the seam on the rear, away from the holes, for a clean look (optional)

If your circle sags, add an organic support. My prints have worked without support, however.