Gardena female connector with diffuser

At water taps of this kind the water always fans out like shown on the picture. With this quick connector, it comes as a jet that pulls a bit of air to diffuse some of the jets energy (less splashing on impact). Also a version with no holes for higher pressures.

Prints on the connection side without support. Use brim. I printed with 3 perimeters in PLA. Make sure to push and turn it a bit al the way, so the sealing (O-ring) seals properly. So far i tooth broke off, but it holds.
I have not tried it, but probably printing it in an angle with support would fix that.

Mind the small air holes on the side. If you push a hose on top of the thing, water will shoot out of the holes.