Handlebar stand for VanMoof S3/X3 (or any bicycle)

Use these stands to put your VanMoof upside down without damaging the handlebars. 

I've included multiple versions: 

1. Simple: Print the whole thing in TPU.
2. Overengineered but better looking: print the base in any material you want. The inside pad and foot should be printed in TPU and glued to the base.
3. A STEP file for you to edit and fit to your own bicycle.

Printing.

The foot should be printed ‘as is’ and the other parts are best printed on their sides.

How to use.

Be the owner of a VanMoof that is faulty. Simply owning a VanMoof will probably put you in this category. Print two stands and put them on the cross bar as close as possible to the handles. See the photos for an example. Then flip the bike and set it upside down. The stands should stay clamped to the cross bar. Use a cloth or another soft fabric to put under the saddle when working on an abrassive surface.

Tip.

You could try and replace the TPU parts of the multi material print with simple felt material.

Version 3

The photos show the prototype. The actual stand base is 10mm higher to allow for extra clearance of the handles. I've also made the clamping force a bit higher. I've decided to include the original anyway as it is working quite well. Just keep in mind that it puts the handlebars closer to the floor and has a bit less clamping power.

Fitting before printing the whole thing

As the stand is printed best on its side; you can cut it to only a few mm's high in your slicer to print a test version. This will save time and material.

Update

27/4/22 Corrected an error with the Base file and added a version with the correct indentation for the Foot. Also added descriptions to the files.

29/4/22 Uploaded versions with an inner diameter of 28mm to help the stand clamp tighter to the handlebar.