MLA Piston Pipette Stand

2 versions- brimmed and un-brimmed.  I designed the stand to be printed on its side, as shown in the image gallery.

since I was trying to replicate our previous pipette stand that broke, it is quite thin.  This is not particularly friendly for bed adhesion, so I designed a very excessive brim-pad with rather thick reinforcement walls to prevent detachment and warpage while printing.

The overkill brim must be cut/broken off of the side of the stand.  I used a combination of flush cuts, my utility knife, and a torch to clean up any rough edges and strings.

I printed mine with the brim in cheap black glossy kingroon PETG