Gaggiuino Gen 3 Headless Unofficial ESP32-S3-N16R8 case

Case for headless mod of Gaggiuino which uses the 'hacked' FW from https://github.com/a4vgx7b2M/gaggiuino-esp32-loader.

Will hold the ESP32-S3 devkit (e.g here), JST XH 4pin male header (here), and SD car reader without voltage regulator (here).

Reason I opted to use JST XH over JST PH that the official headless board uses, is so that the original cabling I had used on my Gaggiuino Gen2 with Nextion Screen could be reused straight away.

For optimal results print with layer height of 0.15mm or less. I printed in PLA, though other materials might work as well.

Original onshape project here, in case you need to adjust board height or dimensions slightly for your use.

Wiring:

Pin definitions for reference:

Soldering note: The picture shows wires soldered from the top, however, the latest version of the model requires you to solder wires from the bottom of the board.