Switch 2 Headrest Mount

A Switch 2 Car Headrest Mount that fits headrests with 14 mm (0.55 inches) diameter rods, and 150 mm (5.9 inches) between the center of the rods. Tweak the seat attachments if you have a different sized headrest, or message me and l'll model a tailored one.

When I printed mine, I used less than 50 grams of PLA, and combined printing time was less than an hour. No supports or brims where necessary.

OPERATION:

1. Place the "controllers" into the Switch 2 and slide on the back piece ensuring that it locks on properly. Make sure the controllers are not upside down.

2. Attach the seat attachments to the headrest.

3. Lock the back piece on to the seat attachments using the pins.

I have used my own PLA print a few times now, and it seems like assembling the whole mount before snapping it on to the headrest works well.

DISCLAIMER: Use at your own risk. Assemble correctly.

Ver. 1.1: Strengthened locking mechanism on back piece.