Case for ESP32-C6 1.47inch Board

A tight fitting case for the Waveshare ESP32-C6 1.47inch Display Development Board, 172×320, 262K Color, 160MHz Running Frequency Single-Core Processor (Amazon 2025/12).   Every case I found that matched this description was way too long and wide.   This has an access hole for the USB-C at one end and channels so the BOOT & RESET keys are accommodated without being pressed.   I printed this on a fine setting and the board/display fits in tightly so no additional glueing required.   Warning - board might not come back out without a fight so be sure you are ready to install.  There is a little extra space behind the main chip to allow for heat and I left a slim opening on the long edges so the status LED is at least detectable.  This was going in a bathroom so I used PTEG but I am sure PLA and other filament types will work just as well.