January 6, 2026
Description
No supports! I had to enlarge the stl in cura to 102.5% but it did fit just a bit tight at regular size. Chamfered cable entry to ensure reduced strain on the cable. Can be used without screws however not as stable.
The usb extender is used was: https://amzn.eu/d/58FCGHE
To install, screw the mount down and then pencil over the area where the cable needs to go before removing the cover. Drill a few holes and file down until the usb is a tight fit (feed in from the top as the cable is thinner at the end ) and then slide the cover back onto the cable and secure.
License:
Creative Commons — Attribution — Noncommercial — Share Alike
TobyAM09
