Teenage Engineering CM-15, TP-7, and TX-6 Cases

Cases for the Teenage Engineering CM-15, TP-7, and TX-6. I didn't find any small form factor cases that fit my needs. The cases and bags I found were either larger than I was looking for, or didn't provide enough protection if thrown in a bag for travel.

The cases are a tight fit, and I would strongly recommend only using TPU or other soft filament. You may damage your device with hard filament, and the fit is tight enough the devices could get stuck.

I added finger holes to take the tops off, and finger holes to remove the devices from the bottom. You may need to slightly push on the back while flexing the sides to get them out. You could also slightly scale it up if you find it too tight for your taste, but they work great as is with flex filament.

I printed on a Prusa XL and printed the first few layers out of PETG to add rigidity and extra crush protection. Printed with BiQu Morphlex and Prusamnet PETG.