Sat Skull Platform V2 (motion sensor)

The link to the model for the Sat Skull doesn't work anymore.

If you need the model just DM me.

Dimensions:

• Height:                 41mm

• Top:                      ⌀90mm

• Bottom:               ⌀173mm

• Sensor hole:        ⌀23

• Switch holes:      19,6 x 12,8mm

• PSU cable hole:  ⌀7mm

Print instructions:

• Print in the orientation the model is made

• Support is needed for the motion sensor and switch holes

• The pin hole is designed, so you don't need supports (you may need to place support blockers)

• The instructions for the skull itself can be found on my Version 1

What you need:

• Electronics:

  • Power supply (4.5V/0.5A in my case)

  • Motion Sensor: HC-SR501

  • Mosfet: IRLZ44N

  • Cables

  • 2 LEDs

  • 2 switches

  • Resistors

• glue to fixate the motion sensor

• 4 small wood screws for the bottom plate (optional)

I got all my electronics very cheap at aliexpress. Except the PSU witch was an old one I just reused.

Circuit diagram: