Cat treat lid - reuse for storage

Print in PETG. Infill doesn't matter - this is a very thin model.

Version 1: To use, the clips go on the outside of the container. I found that pushing one corner diagonally into the lid makes it easier to put it on. This is the only remixed version. 7.05m of filament. Print time 39 mins.

Version 2: I redesigned the entire lid. It snaps on and off without breaking. 8.39m of filament. Print time 39 mins.

Version 3: Redrawn from scratch. This version is a tight fit and snaps around the entire container. Material use is far less than previous versions: 5.44m. Prints in 24 mins

Version 4: Added a lip to make it easier to get the lid off.

Note: only V1 and V2 are a remix of the original. V3 and V4 are my own design.