Plant Stand

Files for three separate applications of my device are included: (1) table/desk lamp only, (2) lamp plus small plant such as Venus Flytrap and (3) lamp sans plant but base filled with fine, white hobbyist sand to facilitate smoking - note cigarette holding features for either Kings or Slims. Additionally there are two distinct files for Top: -09 for under mount of the puck light, said light being held in place by straight adhesive or by a slim steel disc said disc having a peel off adhesive 3M covering, the puck light being furnished with a magnet as purchased or Top-10 for above mount by virtue of a set in triplicate of ClipLED-01, M4 or #8 x 5/8” screw, and M4 or #8 nut. Two files are provided for Base-10 – i.e., with and without additional coring at the rim. All the files can be printed in PLA with exception of the smoking application in which case I recommend ASA for the base.

It’s imperative to use the specific puck light, available from Amazon, shown for proper fit up to the Top, be it under or over mount. This particular light comes with a nifty hand controller too. Flower pots must be 95mm in diameter or smaller. The .500” diameter rods can be of any material and length you like. I highly prefer clear Lucite in lengths of either 6.3” or 12”.

For additional securement I recommend adding 10-24UNC-2B setscrews to the top and base although this is not necessary. To do this clean out the holes with a #25 .149 drill prior to tapping, both operations being easily accomplished by hand with the bit or tap being held in a drill chuck.