Magnetic door stopper and holder

This is an articulated door stopper and holder using 10mm x 3mm round magnets, up to 7 pieces. A M5 50mm bolt is required to connect the 2 parts.

The magnets are embedded into the door siding part. To embed the magnets the print must be paused at 4.2mm (z) hight.

The total width/hight is 80mm, to have room for a door handle also.

In case of metal doors this will be sticking to the door side, in case of other door materials a large washer is needed on the door. These are available usually in magnet shops.

There are 3 mounting holes for wall mount (center or 2 sides) for up to 4mm screws.

For best results and having also some flexibility, cushioning effect, I recommend to print on out of TPU.

3 walls and 15% infill should be fine.