Levoit LVAC-200 Vacuum, 1- or 2-Tool Holder

@PrusaFan123's model fit fine, but it only allows 1 tool to be attached. In addition, the tool attaches to the back of the vacuum, which prevents me from laying the vacuum horizontal to the ground. I tend to vacuum under beds, couches, and shelves, and I need to lay the vacuum as flat as possible.

I created a remix that allows you to attach 1 or both provided tools, and the tools are attached to the sides of the vacuum. Variations include:

• A version where the holder is mounted to the upper portion of the vacuum tube (seen in pictures).

• A version where the holder is mounted to the lower portion of the vacuum tube.

I used M2.5x10mm socket head cap screws. The 2-tool-holder uses 8 screws while the 1-tool-holder uses 6 screws. You can get a set like this: https://www.amazon.com/dp/B0DCKG5BLG

The following are the correct files to print for the version you need:

• Holds 2 tools, mounts to UPPER portion of the vacuum

  • levoit-lvac-200-TWO-tool-holder-UPPER-stick-BACK-part.stl

  • levoit-lvac-200-TWO-tool-holder-UPPER-stick-FRONT-part.stl

• Holds 2 tools, mounts to LOWER portion of the vacuum

  • levoit-lvac-200-TWO-tool-holder-LOWER-stick-BACK-part.stl

  • levoit-lvac-200-TWO-tool-holder-LOWER-stick-FRONT-part.stl

• Holds 1 tool, mounts to UPPER portion of the vacuum

  • levoit-lvac-200-ONE-tool-holder-UPPER-stick-BACK-part.stl

  • levoit-lvac-200-ONE-tool-holder-UPPER-stick-FRONT-part.stl

• Holds 1 tool, mounts to LOWER portion of the vacuum

  • levoit-lvac-200-ONE-tool-holder-UPPER-stick-BACK-part.stl

  • levoit-lvac-200-ONE-tool-holder-UPPER-stick-FRONT-part.stl