March 30, 2022
Description
Following the same idea of my previous design for the front bace, I made this small back brace. It doesn't need to be bigger than this because I can anchor it to my base. Hope you like it!
I made the screw holes a little bigger than the previous design (about 4.5 mm wide) for a better fit.
Printer:
Anet A8
Rafts:
No
Supports:
No
Resolution:
0.2mm
Infill:
25%
Notes:
I also printed this one at 0.15mm layer height, but at 0.2 will be just OK too.
License:
Creative Commons — Attribution
7
Mikel
