Original saber hilt (Hunter)

First major assembly saber hilt.  Made up of 70 pieces.  No glue required, however it is my first attempt and depending on print and tolerances you may need or want glue in some areas.  I assembled mine without. It's a hand and a half hilt so if it's too long for you there's an optional shorter shaft.  Until I create an assembly instructions think of it like a puzzle.  You will need..

18x Grip

39x Trim Button

2x Fin1

2x Fin2

2x Crystal Wall

and 1x of all other parts

Only non printed pieces you will need are..

-a small 3/32" (2.38-2.40mm) rod or dowel about  1 1/4" long.  I used 3/32" brass rod from Ace.

-a #6-32 x 1/2" machine screw and nut