March 31, 2022
Description
This is a replica of figure C from the box "Wizard's Room", number 2009 from Grenadier
(see http://www.dndlead.com/grenadier/ADandD/2009.jpg )
Reproduced using https://www.thingiverse.com/thing:1762299
"Work desk w/ components"
This shipped as a 2-piece model. Since I did not glue the 2 pieces together, I was able to scan them separately, which was good because I don't know how I would have imaged the underside of the table otherwise. Two separate model files are included. They are sized slightly differently, so pay attention to the printing instructions.
Note that I had considerable difficulty printing this model, with Cura disconnecting from the printer, printer stopping midprint, failing to extrude filament properly, etc. I suspect that the wizard has put a curse on the table. You have been warned!
Printer Brand:
Monoprice
Printer:
Maker Ultimate
Rafts:
Yes
Supports:
Yes
Resolution:
0.1mm
Infill:
25%
Filament: eryone PLA white
Notes:
I had to use a raft for the table top, otherwise it warped.
Print at 185% to match original, set Z = -0.2mm
Table legs require supports. Print at 195% to match original.
My printing fellow suggests printing the legs upside down, and sunk slightly into the build plate (perhaps -0.2mm) to make the surface flat, so the table top rests on it smoothly. Sounds good to me!
License:
Creative Commons — Attribution — Noncommercial — Share Alike
engineer27
