Minolta 49mm lens cap clip

When I got my camera, it came with a lens cap, but only half a clip. I used that clip and reproduced a complete clip that would grab onto the 49mm Rokkor lens thread, and matched the styling of the original clip.

Printing recommendations:

1. 0.4mm nozzle

2. 0.12mm layer height

3. 100% infill

4. No supports

5. Make sure the printing seam is not on the clips, but on any of the arches instead

Assembly:

1. Make sure the threads are clean, and the surfaces that touch the cap don't have any excess material

2. Press both ends so that the sides arch outside and upwards

3. Slide the clip into the lid